Hello,
This is one occasion that using a professional rigger is in your best interest. I have done the DIYS approach on this in the past and been unpleasantly irritated about resulting issues that I was not aware of. There are two key issues of concern, 1 putting holes in your mast up to 1" in diameter is a big deal and if done incorrectly can potentially weaken the mast and cause a failure. 2. Electronics are quite spendy, you really do not want to do a substandard instillation that may cause them to fail in the future. You can get all kinds of advise on forums like this on what the best approach is, but the best approach really is to hire a professional rigger for a couple hours minimum to come down and advise you on how best to approach the task at hand. There are all kinds of variables that may not be taken into consideration when your only goal is to get something on mounted on the stick.
Jake
|