[IMG]
Uploaded with
ImageShack.us[/IMG][IMG][IMG]
Uploaded with
ImageShack.us[/IMG][/IMG]
I just had another brainstorm.
This may be proof that I have to much fee time, (and am quite possibly crazy!), but:
See photos.
What if the "Antal Ring cascade tensioner" were
inverted, so that the final purchase, (the bitter end), of the tensioner was directed up, and fitted with a snap shackle,
to became the tack-point of the jib?
Therefore, the loose tensioner and stay can be pulled foreword and, with another snap shackle, attached to the deck mounted padeye. Then the jib tack can be snap shackled to the end/tack-point of the system and hanked on the stay, (obviously this could also be done ahead of time). Finally, when the jib is raised and luff tensioned, the pull on the tack will tension the Solent Stay!!!
Admittedly the power and length of the cascade might have to be experimented with to get the proper ratio of stay tension to luff tension, as well as tack height above deck.
OR:
Also what might be possible would be to install some kind of stopper in the last line of the tensioner(as shown),to limit stay tension and allow for separate luff tensioning.
So, what do you think?
Joel Heberlein
P.S. If you feel the urge to giggle I won't hold it against you.
P.S. If it hasn't been done before, and it works, I'm claiming and naming it.
